recommended oil Peugeot 406 C 2004 Owner's Manual

02-02-2004
PEUGEOT SERVICING
Your vehicle benefits from extended service intervals.
¥ For petrol engines: every 20,000 miles (30 000 km) or every two years.
¥ For direct injection diesel engines: every 12,000 miles (20 000 km) or every two years. The service indicator informs you when each service is due; the point at which it is due is calculated from the last indicator zero reset (see corresponding section). This point is determined by two parameters: - the distance travelled,- the time elapsed since the last service. Note:the distance remaining may be weighted by the time factor, in accordance with the driver's style of driving.
The extension of the service intervals means that the engine oil level must be checked regularly: topping up of the oil between oil changes is normal. It is for this reason that the PEUGEOT network invites you to an intermediate visit between regular services.
The date of this service is not shown by the service indicator. It is to be carried out at least every 10,000 miles (15 000 km) for petrol engines and every 6,000 miles (10 000 km) for direct injection diesel engines.
A PEUGEOT dealer will carry out a quick check, and will top up the levels if necessary (oil, coolant, screenwash up to 2 litres). If the oil level is too low there is a risk of serious damage to the engine: check the engine oil level at least every 2,000 miles (3 000 km) or 3,000 miles (5 000 km), depending on the conditions of use The extended service intervals have been made possible by technical modifications to the vehicles and lubricants:
THUS IT IS ESSENTIAL TO ONLY USE LUBRICANTS WHICH ARE SUITED TO YOUR ENGINE AND RECOMMENDED BY
THE MANUFACTURER (see pages on "Lubricants").
MAINTENANCE OF YOUR 406 COUPE
18

02-02-2004
DIESEL
DIESEL
PETROL PETROL
(1) Minimum quality standard: Petrol engines ACEA A3 and API SH/SJ; Diesel engines: ACEA B3 and API CF/CD
ACEA = Association des Constructeurs EuropŽens Automobiles (Association of European Automobile Manufacturers) -
API = American Petroleum Institute.
If oil is used which does not conform to the ACEA A3-B3 standards, this requires the "Arduous Conditions" servicing schedule to be followed, which involves shorter intervals between services.
Use only 5W40 synthetic oil for the HDI Turbo Diesel engines with particulate emissions filter.
* Fuel Economy Oil cannot be used for the 2.2 litre 16V petrol engine and the HDI Turbo Diesel engines with particulate emissions filter.
TRADE NAMES OF RECOMMENDED LUBRICANTS IN EUROPE(*)
24

02-02-2004
25
MAINTENANCE OF YOUR 406 COUPE
Recommendations for approved lubricants
The oils which appear in the table oppo-site are suitable for most purposes. The diagram opposite states the opti- mum range of viscosity depending on thetemperatures at which the oils are to beused. It is also possible to use synthetic oils of "superior quality". In the absence of semi-synthetic or syn-
thetic oils, oils of ACEA A1/A2 and API
SH/SJ/SL quality (for petrol engines), or
ACEA B1/B2 and API CD/CF quality (fordiesel engines) may be used by followingthe 'Arduous Conditions' servicingschedule, which specifies shorter serviceintervals. Do not hesitate to ask for advice from a
PEUGEOT dealer to maintain drivingpleasure and to minimise the mainte-nance cost of your vehicle. For countries outside Europe, please
contact a local PEUGEOT dealer.
ONLY ONLY
Manual Gearbox ESSO GEAR OIL BV TOTAL TRANSMISSION BV 75W-80 PR 9736.41 75W-80 PR 9730.A2
ONLY
Automatic Gearbox PR 9736.22 ESSO ATF 4HP20-AL4
Power steering ESSO ATF D TOTAL FLUIDE AT42 PR 9730.94 PR 9730.A3
Power steering FLUIDE DA PR 9730.A1*
Brake circuit PEUGEOT DOT4 Cooling circuit
PROCOR TM108/GLYSANTIN G33 or REVKOGEL 2000 ONLYProtection to minus 35 degrees Celsius
* Only for extremely cold countries. Other recommended products

02-02-2004
CHECKING THE LEVELS Oil level Check the level regularly and top up between changes. Maximum con-sumption is 0.5 litres per 600 miles(1 000 km). The oil level should be checked with the vehicle level and the engine coldusing the oil gauge or the dipstick.Dipstick There are two marks on the dipstick: A=maximum
Never fill past this mark. B= minimum
To maintain the reliability of the engines and of theemission control sys-tems, the use of additivesin the engine oil is prohib-ited.
Oil change According to the information given in
"PEUGEOT SERVICING" .
Note: avoid any prolonged contact of
used oil with the skin.
Viscosity selection In all cases, the oil selected must meet the manufacturer's require-ments.
MAINTENANCE OF YOUR 406 COUPE
30
Brake and clutch fluid level:
- The level should always bebetween the DANGER and MAX
marks on the reservoir.
- If the level drops substantially, con- tact a PEUGEOT dealer immedi-
ately.
Fluid change:
- must be carried out according to the manufacturer's servicing schedule.
- use fluids recommended by the manufacturer, which fulfil DOT 4standards.
Note: the brake fluid is noxious and
very corrosive. Avoid any contactwith the skin. Coolant level Use the fluid recommended by the
manufacturer. When the engine is warm, the tem- perature of the coolant is controlledby the engine fan. Because this fan
can operate with the ignition off andbecause the cooling system is pres-surised, wait for at least one hourafter the engine has stopped beforecarrying out any work.
To avoid any risk of burns, slacken the cap to the first notch to releasethe pressure. When the pressure hasdropped, remove the cap and top upthe level. Used products Do not dispose of used oil, brake fluid or coolant down drains or on theground. Power steering fluid level Open the reservoir with the engine
cold at ambient temperature. Thelevel should always be above theMIN mark, close to the MAX mark.
Windscreen and headlamp* wash fluid level For best quality cleaning and for your
safety, we advise that you useproducts recommended by
PEUGEOT.
* According to destination.

02-02-2004
The electrical system of your vehicle is designedto operate with standardor optional equipment.
Before installing other electricalequipment or accessories on yourvehicle, contact a PEUGEOT
dealer. Some electrical accessories or the way in which they are fitted canhave damaging effects on theoperation of your vehicle; theelectronic control circuits, theaudio circuit and the batterycharging circuit. PEUGEOT will not accept respon- sibility for the cost incurred inrepairing your vehicle or for recti-fying malfunctions resulting fromthe installation of accessories notsupplied and not recommendedby PEUGEOT and not installed inaccordance with its instructions, inparticular where the equipment inquestion consumes more than
10 milliamperes.
MAINTENANCE OF YOUR 406 COUPE
40
Engine compartment fuses Fuse box
To access the fuse box in the engine compartment (beside the battery),
unclip the cover. Carefully close the cover when you have finished.
Fuse N¡ Rating Functions
1* 10 A
Reversing lights - Double injection relay - Engine oil
temperature - Oil level - Air conditioning compressor.
2* 15 AFuel pump - Canister solenoid valve.
3* 10 A Control unit.
4* 10 A Engine control unit and automatic gearbox.
5 10 A Particulate Emission Filter control unit.
6 15 A Front fog lamps.
7 20 A Headlamp wash.
8* 20 A Direct petrol injection engine control unit - Clutch pedal.
9* 15 A Left-hand dipped beam.
10* 15 A Right-hand dipped beam.